Live
- The first day of Group-2 Paper 1, 2 exams in Wanaparthy district ended peacefully, said Additional Collector Revenue G. Venkateswarlu
- VP Dhankhar urges corporates to invest in education
- Punjab DGP, MHA official request farmer leader Dallewal to end 20-day fast
- Stage Collapse During Swearing-In Ceremony of KUDA chairman in Kakinada
- Govt unveils ‘Jalvahak’ to boost inland waterways
- List of criminals: Delhi BJP chief on AAP panel of 38 candidates
- PSBs in India clock record Rs 1.41 lakh crore in net profit in FY24
- Telangana Government Announces Key Development Plans: Bhatti Vikramarka
- Crackdown on illegal poppy farming in Manipur: Assam Rifles destroyed 6,228 acres in 5 years
- South Korea's ruling party leader cancels press conference amid calls for resignation
Just In
IIT-Hyderabad predicts lifetime of SARS-COV-2 droplets
A study conducted by IITH faculty shows the importance of properly sanitising contact-prone surfaces
Kandi: An interdisciplinary research group of faculty at Indian Institute of Technology, Hyderabad,has predicted the lifetime of SARS-CoV-2 droplets on surfaces in different environmental conditions,such as ambient temperature, relative humidity, and volume and composition of droplets. Respiratory infections such as the SARS-CoV-2 virus spread primarily by respiratory droplets (size > 10m) of saliva or discharge from the nose of an infected person during coughing/sneezing. Fluid dynamics plays an important role in the study of the life of these droplets migrating in the air or deposited on surfaces.
It was noticed that the spread of virus is minimal after drying of droplets containing virus. The study focussed on various factors affecting the drying time of saliva droplets whereas earlier studies were based on water droplets.
Saliva droplets consist of salt, protein (mucin), and surfactant (dipalmitoylphosphatidylcholine) in addition to water. These ingredients delay the evaporation of respiratory droplets significantly as compared to pure water droplets.
Increase in humidity will make the droplet to take longer than an hour compared to a droplet under a lower humid environment that will dry-up in minutes.Lower ambient temperature also increases the drying time of the droplet.
The angle made by a droplet on the surface (which is known as "contact angle") plays important role in the drying time of the droplet and hence highly hydrophilic surfaces maybe less susceptible to prolonged contamination.
Saliva droplets consist of salt, protein (mucin), and surfactant (dipalmitoylphosphatidylcholine) in addition to water as reported in the earlier study published in the Journal of Royal Society Interface.
By conducting a theoretical and numerical study, Dr Saravanan Balusamy and Dr Sayak Banerjee from the Department of Mechanical & Aerospace Engineering and Prof Kirti Chandra Sahu from the Department of Chemical Engineering of IIT-H showed that these ingredients delay the evaporation of respiratory droplets significantly as compared to pure water droplets. The work appeared in the International Communications in Heat and Mass Transfer, a leading journal in this field.
Dr Saravanan Balusamy said,"A simple classical theoretical model developed in this study that takes into account the dynamic contact angle and the insoluble surfactants is capable of accurately predicting the evaporation time under different conditions."
"The time taken by saliva droplets to dry up also depends on the nature of the surface material on which it falls as it dictates how far the droplet spreads out", said Dr.Sayak Banerjee.
Prof Kirti Chandra Sahu, said, "While the lifetime of a small saliva droplet of size 1 nanolitre is less than a 1 minute, a normal size saliva droplet of 10 nanolitres takes more than 15 minutes to evaporate at room temperature and relative humidity of 50 per cent. For high relative humidity, say of greater than 90 per cent, the droplet stays live on the surface for significantly longer, about an hour.Of course, viruses could still be alive in dried droplets, which requires further research involving biologists."
The longest drying times are observed with the combination of low ambient temperature and high relative humidity, while the drying time progressively reduces as the humidity falls and the temperature rises. Researchers also found that for a fixed initial volume of the droplet, increasing the initial contact angle increases the drying time. This follows physical intuition, as a droplet with a smaller contact angle has a greater wetting radius and surface area for the same volume resulting in a larger interface area over which the diffusion-driven evaporation can occur. Thus, highly hydrophilic surfaces maybe less susceptible to prolonged contamination in comparison to less hydrophilic surfaces, which is somewhat a counter-intuitive result.
The study conducted by IITH faculty shows the importance of properly sanitising the contact prone surfaces in different seasons and air-conditioned indoor areas and suggest to followWorld Health Origination(WHO) guidelines, such as wearing facemasks and maintaining social distance as the preventive measures for airtransmission of COVID-19.
© 2024 Hyderabad Media House Limited/The Hans India. All rights reserved. Powered by hocalwire.com